Item: 4-Claw Tile Backer Board Washers

Material: galvanized steel (stainless steel 304 material also available)

Size: 1-1/4" / 32mm

Center Hole: 5mm

Thickness: 0.6mm

Advantages:

1. Easy to use and install: Each washer has tabs for pre-positioning prior to driving the
fasteners.

2. Durable Tile Backer Board Washers: These tile backer board washers are made of

galvanized steel material or stainless steel 304 material, they are with high hardness, durable, not easily deformed, anti-wear and anti-corrosion.
3. Seamless Installation: Our perforated tile backer board washers can be grip tightly into the surface after secured with the appropriate steel screws. And the perforation for the

tile backer board washers allows the adhesive or plaster to stick to the board’s surface, which could max reduce the risk of surface delamination or damage..
4. 4-Claw Design: The 4-Claw design for the tile backer board washers can fix the panel more firmly, and become almost flush with the board.
5. Wide Application: Ideal for insulation boards, tile backer boards, gypsum boards,

composite boards extruded plates, or just fixing construction boards to frames.

Item: Tile Backer Board Washers

Material: stainless steel 304

Size: 36mm

Center Hole: 5mm

Thickness: 0.6mm

Item: Tile Backer Board Washers

Material: galvanized steel

Size: 36mm

Center Hole: 5mm

Thickness: 0.6mm

Item: Tile Backer Board Washers

Material: galvanized steel

Size: 35mm

Center Hole: 5mm

Thickness: 0.7mm

We would highly recommend using 15 tile backer board washers per 1200 x 600mm board. This is however only a rough guide to the number of washers needed to be used with the tile backer boards.

Specially its depended upon the material, thickness, subsurface, and the final floor covering to be put onto the boards.

Tile backer board washers can be used on either wall or on floors.

It is the responsibility of the installer to use the correct number of washers that hold the board firmly in place.